Don't stop to work for a long time not only for our human body has certain harm, which in turn on the equipment we use is bad, don't don't think so, because the device is a life we've been to for a long time in the work to the harm of water glass equipment after we are clear.

Sodium silicate equipment long-term operation, the bearing is laden with sodium silicate loading all of the equipment, and for sodium silicate bearing on sodium silicate troubleshooting monitoring equipment on both ends of the bearing inspection, sodium silicate equipment at the ends of the cylinder bearing supporting the whole system, status is important. Bearing and water glass equipment the most common and one of the components easily damaged. Sodium silicate equipment bearing long-term fatigue wear, peeling, live load can make the water glass equipment, bearing deformation, corrosion, fracture, glue and other reasons can lead to bearing damage, bearing damage will impact vibration, using the shock wave height ratio, can be used as markers of oil bearing damage in varying degrees. By excluding detection to sodium silicate equipment bearing system can timely grasp the extent of the bearing damage and damage parts, how long can also estimate the bearing work to reach the critical level or nearby criticality alarm in time, not appear serious accidents such as burning shaft.

In addition to this, after all preparations were made, the start of the overflow water glass equipment test run for the first time, pay attention to the electric note changes sodium silicate equipment shall start no more than two consecutive times, the first and second every 5 minutes or more, such as check to start a third time, must do some check again to make sodium silicate equipment started running after work. Sodium silicate in normal operation, we will strictly according to the provisions of the water, feeding the ban on overstretched, idle time is not more than 15 minutes, so as to avoid breaking plate. Sodium silicate equipment downtime or when starting again after a long downtime should go first to pour a small amount of lubricating oil on hollow bearing, and artificial plate mill for a week, or "dot" to revolve, confirm no abnormal phenomenon.